PVI Industries Water Heater PV 6127b User Manual

SPECIFICATION FOR DOMESTIC WATER HEATERS  
Atmospheric Combustion, Gas-Fired Water Heaters  
with Polymer-Lined Storage Tanks  
Furnish and install atmospheric gas water heater(s) as manufactured by PVI Industries, L.L.C.  
of Fort Worth, Texas. Supply quantities and model numbers as indicated on the plumbing schedule.  
Gas and Electrical Consumption  
The water heater will operate at 80% thermal efficiency. The water heater will comply with paragraph 7.2.4.4, the  
thermal efficiency, the standby loss, and all other requirements of ASHRAE 90.1-1999.  
Pressure Vessel and Heating Surfaces  
The water heater will be a vertical fire tube design that is constructed and stamped in accordance with Section IV,  
Part HLW of the ASME code. Both the storage and heating sections of the water heater will be National Board  
Registered for a working pressure of 150 psi and will be pressure tested at 1-1/2 times working pressure. The fireside of  
the heating surfaces will be of boiler-grade steel. The waterside of the heating tubes will be sealed in copper. The  
heating tubes will be rolled, beaded, and seal welded into the tube sheets. The combustion side of the tube sheet will be  
insulated by a layer of ceramic fiber that will protect the tube sheet from both thermal stresses and failure that can result  
from the accumulation of scale and precipitants.  
Tank Lining  
The lining will:  
be applied only after the tank is completely fabricated and all welding is completed.  
consist of multiple applications of high-temperature fluoropolymer.  
be third-party tested to and comply with NSF 61standard.  
be continuous and nonporous with no interruptions or discontinuities.  
require no sacrificial anode rods for protection.  
Burner and Venting  
Combustion will be provided by an atmospheric burner with a gas train meeting the following agency requirement for  
the input specified:  
___ UL (standard)  
____ FM  
___ IRI  
___ Other ______________________  
Water heater will be a category 1, non-condensing appliance. It will be UL-listed for use with non-pressurized, type  
B venting material.  
Safety Controls  
As a minimum, the heater will be equipped with the following:  
electronic flame monitoring  
two immersion operating thermostats  
an immersion temperature limiting device  
an ASME- or AGA-rated temperature and pressure relief valve  
and options as selected on form PV 6071  
(continued)  
PV 6127b 6/01  
1
 

Peavey Microphone AAM 835 User Manual
Peavey Music Mixer XR 600E User Manual
Pelco Home Security System C2915M E User Manual
Philips Flat Panel Television 19PFL3403 77 User Manual
Philips Home Theater Server NP3900 12 User Manual
Plantronics Headphones W440 M User Manual
PLUS Vision Projector V 339 User Manual
Polaroid Flat Panel Television FXM 3211C User Manual
Poulan Tiller 433154 User Manual
Precor Treadmill M955 User Manual