C2931M (7/05)
PMCD750 DLP™ Display
Removable On-Screen Code Chart
The PMCD750 will flash a sequence of red and amber lights on the screen to indicate current status or if a fault exists. Cut out these cards for convenient
referencing of the on-screen codes.
Condition
Priority
Each block represents 0.2 seconds
R
Door open
1
2
R
R
R
R
R
R
R
R
R
Power supply fan failed
DLP fan failed
Amber
Amber
3
R
350V failed
4
R
R
R
R
R
Amber
Optical engine failed
5
Amber
R
Lamp failed
6
R
R
Lamp off (wait, auto off)2
Wait (lamp off, cooling)
Lamp off (lamp saver)3
Lamp off (ready to turn on)
Lamp striking (starting)
Lamp on, no alarms
7
Amber
Amber
Amber
8
R
R
9
Amber
Amber
Amber
Amber
Amber
Amber
R
10
11
12
Amber on continuously
R = Red
To show the code, press MONITOR button once.
1With Priority 1-6, to turn lamp on, cycle off, and then on. If Auto Codes in the Miscellaneous menu is checked, events with Priority 1-5 start the
on-screen code automatically.
2Lamp Saver turned lamp off; lamp is cooling and will turn on at end of cooling period.
3A Lamp On command from the remote or from RS-232 commands will turn lamp on.
Condition
Priority
Each block represents 0.2 seconds
R
Door open
1
2
R
R
R
R
R
R
R
R
R
Power supply fan failed
DLP fan failed
Amber
Amber
3
R
350V failed
4
R
R
R
R
R
Amber
Optical engine failed
5
Amber
R
Lamp failed
6
R
R
Lamp off (wait, auto off)2
Wait (lamp off, cooling)
Lamp off (lamp saver)3
Lamp off (ready to turn on)
Lamp striking (starting)
Lamp on, no alarms
7
Amber
Amber
Amber
8
R
R
9
Amber
Amber
Amber
Amber
Amber
Amber
R
10
11
12
Amber on continuously
R = Red
To show the code, press MONITOR button once.
1With Priority 1-6, to turn lamp on, cycle off, and then on. If Auto Codes in the Miscellaneous menu is checked, events with Priority 1-5 start the
on-screen code automatically.
2Lamp Saver turned lamp off; lamp is cooling and will turn on at end of cooling period.
3A Lamp On command from the remote or from RS-232 commands will turn lamp on.
Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com
USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150
International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120
Pelco and the Pelco logo are registered trademarks of Pelco.
DLP is a registered trademark of Texas Instruments, Inc.
©Copyright 2005, Pelco. All rights reserved.
|