Setting Up your XV-DV430 DVD/CD Receiver
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.
Do not use these speakers with any other system or amplifier as this may result in damage or fire.
Using the remote control
The remote control can be used within a range of about 21 ft from the remote sensor on the front panel, and within a 30
degree angle.
Check that you have all the accessories, then put
the batteries in the remote control.
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.
2
1
Precautions:
Batteries and
remote control
•
The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote
control is not directed towards the remote sensor of the display unit at the correct angle.
The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the
unit’s remote sensor.
The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote
Pull off the protective
1
•
Power cord
shields of both AM antenna
STANDBY/ON
CD
FM/AM
TUNER
L1/L2
LINE
•
DVD
TV
fig. A
fig. B
fig. C
wires.
DISPLAY
OPEN CLOSE
0
controls of other devices which use infrared rays are used. Also, the use of this remote control may cause other devices to
work improperly.
8
1
3
7
¡
4
4
•
When the operating range of the remote becomes too short, replace the batteries.
4
DVD MENU
RETURN
Push open the tabs, then insert
one wire fully into each terminal.
2
3
TUNE+
ST–
ST+
ENTER
TUNE–
MUTE
SOUND
Remote control battery caution
Incorrect use of batteries may cause leakage or rupture.
Always be sure to follow these guidelines:
•
MASTER
VOLUME
Video cord
TV CONTROL
6
CH
INPUT
VOL
Release the tabs to secure the AM
antenna wires.
Always insert batteries into the battery compartment correctly matching the
positive ª and negative · polarities, as shown by the display inside the compartment.
OPEN
•
•
•
Never mix new and used batteries.
Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries.
When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules
1
Fix the AM loop antenna to the
attached stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. A) then
clip the loop onto the stand (fig. B).
2
4
that apply in your country or area.
In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one
FM antenna
3
•
month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries
with new ones.
•
AM
FM
LOOP ANTENNA
UNBAL 75Ω
AM loop antenna
ANTENNA
Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing
faster exhaustion of the batteries.
Satellite speakers:
•
•
•
•
•
Center (1)
Note: If you plan to mount the AM antenna
to a wall or other surface, secure the stand
with screws (fig. C) before clipping the loop
to the stand. Make sure the reception is clear.
Front/Surround (x4)
Subwoofer (1)
Additional notes on connecting antennas
•
•
•
Keep antenna cables away from other cables and the display unit and main set.
To assure optimum reception, pull the FM antenna so that it is fully extended and not coiled or hanging at the rear of the unit.
If reception with the supplied antenna is poor, see the Additional Connections section in the main operating instructions
Speaker cords (x6)
Non-slip pads (x24)
for details on connecting outdoor antennas.
Place the AM antenna on a flat
surface and point in the direction
giving the best reception.
Don’t let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
5
6
Connect the FM wire antenna to the FM UNBAL 75Ω antenna terminal.
For best results, extend the FM antenna fully and fix to a wall or door
frame. Don’t drape loosely or leave coiled up.
Additional notes on speaker placement
Place speakers as shown in step 4 to achieve the optimum surround sound effect
•
•
•
Install the main front left and right speakers at an equal distance from the TV.
For optimum effect, install the rear speakers slightly above ear level.
This system's speakers are magnetically shielded, so there's virtually no picture color distortion when they are placed near
Note: The signal earth (H) is designed to reduce noise that occurs when an
antenna is connected. It is not an electrical safety earth.
3
1
2
a TV. In the rare event that there is some picture color interference, switch power to the TV off, and wait 15 to 30 minutes
before switching on again.
•
•
Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen.
When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means.
Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or
damaging the speaker.
Connect each speaker as shown below.
Connect each speaker using the color-coded
speaker cords. Match them to the colored labels
above the speaker terminals.
•
Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire.
3
Color-coded wire
(Connect to speaker)
Connect the DVD/CD receiver to your TV, then connect the
supplied power cord.
4
Color-coded connector
(Connect to rear panel)
Surround right
(Grey)
Surround left
(Blue)
Connect one end to a video input on your TV.
Use the supplied video cord.
1
Twist and pull off the protective
shields on each wire.
1
Connect the other end to the video output of the DVD/CD receiver.
2
This player is equipped with copy protection technology. Do not connect this
player to your TV via a VCR using AV cables, as the picture from this player will not
appear properly on your TV.
Connect the wires to the
2
IN
IN
OUT
Connect the power cord to the AC inlet.
speaker. Match the colored
wire with the color-coded
label (above the tabs), then
insert the colored wire into
the red (+) tab and the other
wire with the black (–) tab.
3
L
CENTER
6
SURROUND
6
FR6ONT
Listening position
SPEAKERS
L
L
R
AUDIO
TV
LINE 1
R
R
VIDEO IN
6
6
6
Subwoofer (Purple)
SUB
WOOFER
Connect the other end to the
color-coded speaker jacks on
the rear of the DVD/CD
3
IN
IN
OUT
OPTICAL IN
AUDIO
L
CENTER
SURROUND
FR6ONT
6
6
SPEAKERS
L
LINE
2
L
R
FM
AM
ANTENNA
UNBAL 75Ω
LOOP ANTENN
TV AUDIO LINE
1
R
R
AC IN
6
6
6
S-VIDEO VIDEO
OUT OUT
SUB
Y
P
B
PR
WOOFER
VIDEO
COMPONENT VIDEO OUT
receiver (as shown at left).
Make sure to insert completely.
VIDEO
OUT
VIDEO
Front right
(Red)
Center (Green)
Front left
(White)
AC IN
For the best surround sound, setup your
speakers as above. The front left and right
speakers should be about 6–9 ft apart.
To AC outlet
Remove the supplied non-slip pads from the paper, and stick four
onto the base of each satellite speaker.
Actual speakers supplied may differ from those shown.
These speaker terminals can be hazardous when live. When you connect or
disconnect the speaker cables, to prevent the risk of electric shock, do not
touch uninsulated parts before disconnecting the power cord.
Congratulations! You're done setting up.
Printed in
<XRE3074-A>
|